|
Post by alien_spuds on Jul 10, 2004 12:32:36 GMT -5
hello im farly recent to spud guning but i already have 2 guns! i was woundering what you think of an idea i have for a gun from back to front a 4 inch female adapter with clean out cap any length of 4 inch pipe and then 4 inch male adapter and then 4 inch female adapter then any lenth of 4 inch pipe and 4 inch to 2 inch reducer and how ever you want to make a barrle or inter changeable one. the advantige with this idea is that you could chanbe the length of the chamber when ever you want to just get a new 4 inch clean out cap and male plus female coupling!! what do you think
|
|
|
Post by boogieman on Jul 11, 2004 21:03:56 GMT -5
That sounds like a good idea. I think it would work well.
|
|
Roach
Junior Spud Gunner
Good men must die, but death can not kill their names
Posts: 18
|
Post by Roach on Feb 2, 2005 11:45:03 GMT -5
cool idea
|
|
|
Post by hoarp001 on Feb 18, 2005 18:15:34 GMT -5
it would be quite hard to seal the chamber in to the reducers to prevent leakage whilst still making it easy to remove and replace... maybe some kind of clamp that could pull the two reducers together and clamp the center inside....
|
|
|
Post by DReynolds on Feb 18, 2005 19:48:08 GMT -5
How about the piece used for the breech-loading barrel? I forget the technical term, but it's black and clamps into place. There's a picture of it around this site somewhere.
|
|
|
Post by hoarp001 on Feb 18, 2005 20:27:09 GMT -5
(assuming i am thinking of the same thing as you) the hard part would be clamping the chamber pipe in the fittings... you could have a rubber ring in the bottom of the fittings to be on eiter end and somehow clamp the two fittings together so it holds the pipe inside. see pic. www.gunge-stuff.co.uk/chamberchange.jpg
|
|